Skip to content

Tile, foam or shingle, the why behind every fix: (480) 470-6535

(480) 470-6535

Paradise Valley, AZ

Roofing in Paradise Valley From a Crew That Explains Every Layer

We repair, replace and install tile, shingle, foam and flat roofs on homes in Paradise Valley and nearby Scottsdale. Our first job is finding the part that failed. We point it out, explain why it gave way and describe the fix, from the underlayment up to the ridge.

  • Cause named before price
  • Line-item written estimates
  • Yard covered and swept
  • Permits pulled when required
Three roofers tearing off old shingles from a single-story tan brick home, with a ladder, a debris tarp, shingle bundles and a dump trailer in the driveway

What Shapes the Cost of Your Roof

The covering you see is only one part of the number. The layers beneath it, the shape of the roof and any permit work each add their share, which is why two roofs that look alike from the street can be priced quite differently. These are the things we weigh before anything goes on paper.

We measure your roof and look at its condition before writing anything, then go over the estimate with you line by line. You get your quote by phone after the visit, along with a written copy.

Roof size and pitch
Area sets the amount of material, and pitch sets how fast a crew can safely work. Steeper slopes need more staging and fall protection, which adds labor time.
Material and how much can be reused
Concrete and clay tile can often be lifted, stacked and relaid over new underlayment, which saves buying new tile. Broken or discontinued profiles have to be matched or replaced. Shingle, tile and spray foam each carry different material and labor costs.
What we find underneath
Rotted decking at the eaves, sagging sheathing or old layers that must be torn off all add work. We price what we can see, and if more turns up once the roof is open, we show you before doing it.
Flashing, penetrations and parapets
Every skylight, chimney, pipe, cooler curb and wall junction needs flashing done by hand. A roof with many penetrations or parapet walls takes longer than a plain gable.
Foam thickness and coating
On flat sections, cost depends on whether the existing foam can be cleaned and recoated or has to be removed, how thick the new foam goes and which coating system tops it.
Permits and access
Replacements usually need a permit and sign-off from the town. Tight side yards, landscaping or multi-level roofs can also slow how material gets up and debris gets down.

Roofing Services for Your Home

We handle tile roofing, shingle roofing, foam roofing and flat roofing, along with roof repair, roof replacement and new roof installation. Many homes here combine a pitched tile roof with a low-slope foam section behind a parapet, and each one fails in its own way. Tile usually outlasts the felt underneath it, while foam depends on a coating that breaks down in strong sun. Each service page explains the materials involved, what goes wrong and how we fix it.

  • Terracotta clay barrel tile roof on a single-storey tan stucco home with brown gutter, prickly pear cactus, round shrub and agave in a gravel yard

    Tile Roofing

    Underlayment replacement, tile re-lays and matched replacement pieces for clay and concrete tile roofs, with new flashing at every valley and wall.

  • Roofer kneeling on a roof nailing charcoal architectural shingles, bundles of shingles on underlayment, desert homes, saguaro and mountain behind

    Shingle Roofing

    Asphalt shingle roofs installed and repaired with balanced ventilation, sealed flashing and a nailing pattern set for wind and heat.

  • Worker in white coveralls sprays tan foam across a flat roof beside a white vent, with a stucco house, palm trees and a saguaro in the background

    Foam Roofing

    Spray polyurethane foam for flat and low-slope roofs, from a new foam system over a worn roof to a fresh elastomeric recoat that protects the foam you have.

  • Roofer using a pneumatic coil nailer to install gray architectural shingles, with bare decking nearby and a dump trailer of torn-off shingles in the driveway

    Roof Replacement

    Full tear-off and rebuild of a worn-out roof, with deck repair, new underlayment and flashing, and a cleanup that leaves your yard as we found it.

  • Roofer replacing shingles on a single-story stucco and brick home, with bare decking on one side, a ladder at the eave and a dump trailer of old shingles in the driveway

    Roof Repair

    Leak and wear repairs on tile, shingle, foam and flat roofs, starting with finding the failed part instead of guessing from the ceiling stain.

  • Roofer kneeling on OSB decking with a nail gun, laying dark shingles over gray underlayment, with an aluminum ladder at the gutter and a saguaro cactus behind

    New Roof Installation

    Complete roof systems for new homes, additions and casitas, matched to your plans and built to pass the town's sign-off.

  • Roofer kneeling on a flat roof pressing a new white membrane sheet into place beside a roll of membrane, with vent pipes, a drain and desert mountains beyond

    Flat Roofing

    Membrane and coating work for low-slope roofs, with attention to ponding water, parapet flashing and scuppers so rain leaves the roof instead of sitting on it.

Two roofers in harnesses tear off old asphalt shingles with shovels on a ranch-style home, a ladder at the eave and a dump trailer in the driveway below

A Roofing Company That Works Like a Neighbor

Paradise Valley Roofing does residential roofing and nothing else. We work on the tile, shingle, foam and flat roofs found on homes across the valley, and we spend most of our time explaining them as much as fixing them, because an owner who understands the roof makes better decisions about it.

Desert roofs fail in predictable places. Felt underlayment dries out and cracks under tile long before the tile itself wears, foam loses its protective coating to ultraviolet light, and flashing around cooler curbs and parapets opens up as the roof expands and contracts with big daily temperature swings. We look at those spots first and tell you what we see.

We keep our work to what your roof needs. If a section can be repaired and hold for years, that is what we recommend. If it cannot, we show you why and lay out the replacement plainly.

Where We Work

We are based in Paradise Valley and work on homes throughout the town. We also take roofing jobs in Phoenix, Scottsdale, Tempe, Glendale, Fountain Hills and Guadalupe. The tile and foam roofs in those communities share the same materials and the same weak points, so the work is familiar wherever we go.

  • Paradise Valley
  • Phoenix
  • Glendale
  • Scottsdale
  • Tempe
  • Fountain Hills
  • Guadalupe

If you are not sure whether your home falls in our area, ask when you call and we will tell you straight away. The Service Areas page lists each town we cover.

More on the areas we cover

5 mi10 miPhoenixGlendaleScottsdaleTempeFountain HillsGuadalupeParadise ValleyN

How We Work on Your Home

We run every job the way we would want a roofer to work on the house next door to ours. That shows up in small decisions, made the same way every time.

The cause comes before the quote

A water stain on a ceiling can start ten feet uphill from where it shows. We trace it to the part that let water in, whether that is a cracked tile, brittle felt underlayment, a split pipe boot or foam coating worn down to bare foam. You hear what failed and why before you hear a number.

Repair when a repair will hold

If the underlayment under your tile still has life, we lift the tile, fix the problem area and relay it. When the felt is cracking across the whole slope, patching one spot only moves the leak, and we tell you that plainly with photos of what we found.

Estimates you can read

Tear-off, underlayment, flashing, replacement tile, coating and permit are broken out separately. Every dollar is tied to a named piece of work, and you can question any of it before we start.

Your property treated with care

Before anything comes off the roof, we cover plants, patio furniture and pool equipment. Old material drops straight into a bin, and before the crew leaves each evening we roll a magnet across the driveway and yard to pick up stray nails.

Answers from the people doing the work

The crew on your roof can tell you what they are installing and why. Ask about a flashing detail or a vent and you will get a straight explanation.

Roofing Questions We Hear Most

My tile looks fine. Why would my roof leak?
On most tile roofs the tile is not the waterproof layer; the underlayment beneath it is. Older felt underlayment dries out in strong sun and heat, then cracks, and water that slips past the tile reaches the deck. The tile can look perfect while the layer under it has failed. We lift tile in the problem area to check before recommending anything.
Should I repair my roof or replace it?
It depends on how widespread the damage is. A cracked tile, a failed pipe boot or one bad flashing joint is a repair. If the underlayment is brittle across most of the roof, or a foam roof has lost coating and soaked up water in many spots, repairs will keep chasing leaks. We show you photos and explain which situation you are in.
How often does a foam roof need attention?
Spray foam itself holds up well as long as its coating stays intact, because sunlight breaks down exposed foam. The coating wears thinner over the years and needs a cleaning and recoat before bare foam shows through. Catching it at that stage usually costs far less than replacing damaged foam.
How long will work on my roof take?
A repair to one area is often finished in a single visit. A full replacement takes longer, depending on roof size, how much tile can be relaid and what we find on the decking once the old layers come off. We give you an expected schedule with the estimate and keep you posted if something underneath changes it.
How do I get a price for my roof?
Phone us and describe what is going on. We set up a visit to measure the roof and look at its condition, then go over a written, line-item estimate with you. You get your quote by phone after we have actually seen the roof.
Will a roof replacement need a permit?
Most replacements and new roof installations do, and we pull the permit for you. Smaller repairs often do not. We tell you which applies to your job and handle the paperwork and sign-off when one is needed.
What happens to my yard during the job?
We cover plants, outdoor furniture and pool equipment before tear-off starts and drop old material directly into a bin. Tile we plan to reuse is stacked on the roof or on padded boards, not on your landscaping. At the end of each day we sweep the driveway and yard with a magnet for nails.

How a Roofing Job Runs

Most jobs follow the same five steps, so you know what is happening at your home and what comes next.

  1. 1

    A phone conversation

    You describe the problem, whether it is a ceiling stain, slipped tiles or a soft spot on a flat section. From there we pick a day that suits you for a visit to the roof.

  2. 2

    Measuring and looking closely

    We measure the roof, check the covering, flashing and underlayment where we can reach it, and take photos of anything that needs attention.

  3. 3

    Your options, explained

    We walk you through what failed, what a repair would involve and whether replacement makes more sense. You get a written, line-item estimate to keep.

  4. 4

    The work itself

    We pull any permit, protect the yard and work through the roof in sections so your home is never left open overnight. If we find hidden damage, we stop and show you before going further.

  5. 5

    Cleanup and a walk-through

    Debris is hauled off, nails are swept up and we walk the finished work with you, pointing out what was replaced and why.

Roofer in a harness shows a homeowner tablet photos of damaged shingles on the front lawn while another worker strips the roof of a brick ranch home
Brick ranch house with a dark brown shingle roof, aluminum ladder at the eave, tool bags and tarp in a desert gravel yard with a saguaro cactus

Find Out What Your Roof Actually Needs

Describe the stain, the slipped tile or the soft spot, and we will arrange a visit to trace where it starts. You hear the cause and your options in plain terms before any decision gets made.